my6thgen.org - Maxima Forum

my6thgen.org - Maxima Forum (http://my6thgen.org/)
-   Audio, Video & Electronics (http://my6thgen.org/f30/)
-   -   Advice Needed: Grounding for car stereo adapter PCB (http://my6thgen.org/f30/grounding-car-stereo-adapter-pcb-29278/)

yumi 12-06-2016 04:51 AM

Grounding for car stereo adapter PCB
 
I've built an audio adapter for car stereo system. It contains microcontroller, a connector to stereo system (a few data pins and line-level audio output), Bluetooth audio module (RN52) and power connector.

I've successfully tested it with a separate, floating power supply, and audio noise falls within my expectations.

However, when I power the adapter with a power supply which is also referenced to audio amplifier/speaker system, I am hearing significant noise. This happens in car, but I also hear the same issue on my desk, if I power the PCB from PC's USB port, and speaker system is also referenced to my PC.

I kind of suspect grounding issues on my PCB. When designing it, I did not pay a lot of attention to routing GND pins of the modules/ICs used- I relied on having ground fills on both sides of the PCB.

This is a high-level overview of the PCB I made:
http://i.stack.imgur.com/r7toq.png
I recall having heard about "star ground" concept, where all the ground points should connect in a single place, power input connector.
http://i.stack.imgur.com/bEq1S.png
The questions are:

1) How applicable the star grounding is if there are multiple connectors (each with a separate ground wire), which may, or may not be referencing a "common" ground somewhere further.

2) Is it possible to improve noise with a different/proper grounding on my PCB, or should I isolate either the audio output or power input?


All times are GMT -4. The time now is 10:28 PM.

Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
SEO by vBSEO