- Maxima Forum - Maxima Forum (
-   Engine, Trans, F/I & Tuning (
-   -   Technical Problem: P011 code And Can't Fix It! (

tweets04 08-29-2011 04:31 PM

P011 code And Can't Fix It!
Whats up all. Well I got the P011 code which is over advance timing. Can be camshaft position sensor or the IVT. I have replaced both.... Still throwing the code. Can I test the Position sensor to know if the part is faulty? What else can I do to fix this??:noidea:

NiZMo1o1 08-29-2011 05:15 PM

Re: P011 code And Can't Fix It!
that code IIRC is the cam position sensor ,

you replace BOTH of them ? did you disconnect the battery while doing this to re-set the ECU ? then let it start up and idle for the ECU to go thru the re-learn phase ?

tweets04 10-14-2011 10:23 AM

Re: P011 code And Can't Fix It!
Yes did all the restart stuff. Reset the codes and even used a good scanner on it. The idle will do funny stuff after about 3 minutes of running. Jump up a couple hundred rpms then go back down. The engine was badly neglected though so I have bought a new one and am just gonna replace it.

All times are GMT -4. The time now is 01:53 AM.

Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.